PRIMER METALL
✔︎ For closed surfaces
✔︎ Fast drying approximately 5 minutes
✔︎ Economical to use
✔︎ Easy processing
PRIMER METALL is a treatment for improving the adhesion of various adhesives and sealants on closed surfaces. Primer Metall is a pre-treatment agent and cleaner in one.
Pre-treatment of metal surfaces such as:
-
Aluminium
-
Steel
-
Copper
-
Brass
Pre-treatment of powder coated surfaces. Pre-treatment of lacquered surfaces (pre-test the substrate to check possible attack or slight haze on the surface).
-
Surface must be dry, clean, grease- and dust-free.
-
Keep the can closed until the processing.
-
Turn the can open and pierce the foil.
-
Not available directly from the original packaging.
-
Pour in as much as a glass or tin that can be processed in 30 Minutes, and then close the can immediately again.
-
Primer Metall must be applied in a not too thick layer. T
-
he surface securely wipe with a moistened with Primer Metall, dry, clean, lint free and pigment free cloth or tissue paper. In this way, at the same time, the surface is cleaned and pre-treated.
-
Replace the cloth or paper if it gets dirty.
-
After a drying time of (should evaporate solvents) for about 5 Minutes, the Adhesive can be applied. The best results are obtained when the bonding takes place within 6 hours after the application of Primer Metall.
-
So do not pre-treat more surface with Primer Metall than can be bonded within 6 hours.
-
Avoid contact with the prepared surface as this may affect the adhesion.
Consumption:
-
The consumption of approximately 20m2 per 1 litre.
Comments:
1. Primer Metall is not paintable and therefore it cannot simply be used for surfaces to be painted later. In such a case, only apply the Primer Metall where later the adhesive or sealant is coming, for example by using masking tape. One can also, prior to the treatment of paint, remove the primer layer with for example Power Cleaner. Pre-testing of the cleaner does not affect the surface.
2. Highly contaminated surfaces need to be cleaned first for example with Power Cleaner. Pre-testing if this cleaner does not affect the surface
